Home Improvement Calculators US

Switch among five common project estimators. Each one converts room or lot measurements into order quantities with a waste allowance.

Enter your numbers

Ordering materials without a surplus you cannot return

Most DIY shortages happen because a project is not a perfect rectangle, or because cuts, breakage, and over-excavation were ignored. Each estimator on this page starts with a simple rectangle and then adds a waste percentage you can change. Ten percent is a reasonable default for many slabs, straight-lay floors, and simple roofs; complicated shapes deserve more.

Concrete is sold by the cubic yard (27 cubic feet). A 4-inch slab is one-third of a foot thick, so a 20-by-12-foot patio is a little under three cubic yards before waste. Bag estimates assume roughly 0.60 cubic feet for an 80-pound bag and 0.45 cubic feet for a 60-pound bag; check the bag in your store, because mix designs differ. Ready-mix is usually the practical choice above a small footing or post-hole project, and many plants have a minimum load.

Paint needs are wall area (and ceiling, if you include it) minus a rough allowance for doors and windows, multiplied by coats, then divided by label coverage. New drywall, dark color changes, and rough textures often need primer and extra product. Flooring should be ordered by the coverage you need after waste, not the exact room area; keep a carton for future repairs, because dye lots change. Roofing is measured in squares (100 square feet). Pitch increases the actual surface above the building footprint; this tool applies a uniform pitch factor to a single rectangle and cannot replace a takeoff on hips, valleys, and dormers.

Mulch is estimated in cubic yards and in 2-cubic-foot bags. Two to three inches is a common bed depth. Bulk delivery usually wins on price once the volume is more than about a yard, provided you can place the pile. For every project, confirm local code, permit, and structural questions — especially for roofs and load-bearing slabs — before you order.

Frequently asked questions

How many 80-pound bags equal a cubic yard?

At about 0.60 cubic feet per bag, you need roughly 45 bags to make a cubic yard. That is why larger pours are almost always ordered as ready-mix.

What waste factor should I use for flooring?

Ten percent suits many straight installs. Diagonal layouts, patterned tile, and rooms with many closets or angles often need 12–15%.

What is a roofing square?

One square equals 100 square feet of roof surface. Bundles of asphalt shingles are commonly packed three bundles to a square, but check the product.

Can I add odd-shaped rooms?

Split the space into rectangles, run the calculator for each, and add the results, then apply one waste factor to the total.

Results

Enter figures to see an estimate.